Maneuver

After the store of data Moskito always puts the overview, all areas of the plan or the plans are shown. For the change of plan cutting and level representation varied service possibilities are available. Beside the use of the system menu, the tool bar, the menu strip and the pop-up menu can be worked in the graphics area also interactively with the mouse.

Tip: The Manövrieraktionen are explained immediately, also during you just another action explain as for example while determining a pressure area. Even if Moskito is occupied just with calculations, so, e.g., with printing, you can order at the same time still all functions of the pop-up menu (right mouse key).

Zoom

Because this increase of a partial picture the most frequent case is need to operate for it no button. Simply hold the left mouse key on a corner of the desired cutting low-spiritedly and draw up with the mouse the cutting up to the opposite corner. As soon as you the key will let go the new cutting opposed and the picture anew built up.

Attention: If the cutting is smaller than about 2 cm, you must put this in several passageways because such small areas are identified as a torn to pieces movement. Then Moskito thinks that you wanted to click, actually, only in this position.

To fix a zoom cutting, you can click alternatively also with the left mouse key the symbol shown on the left of the tool box. Then you fix the desired screen window by an easy click in the graphics window to his left lower and right upper corner. Then the graphics window is updated. With this approach you have to go twice with the left mouse key click, then the window is able no more are opened by drawing with the mouse.

By clicking +Symbols or from Fenster|Vergrössern increase They also the graduation of her Plan view. On this occasion, it is automatically zoomed in the middle of the screen.

If you liked to look at a bigger plan cutting again, click on the symbol or the menu point Fenster|Verkleinern. Then the visible screen window becomes bigger again; additional objects are to be seen.

Full image

On clicking the tool box symbol "full image" the whole plan extent is indicated again. Alternatively you can also select in the menu Fenster|Vollbild.

Picture around centre centre

To shift the screen window in such a way that one point elective by you appears in the centre of the graphic arts window, click first on the badge of the tool box and afterwards give the desired centre by click with the left mouse key in the graphic arts window.

Picture run strips

On the horizontal and vertical picture run strips the position of the plan cutting is indicated by square badges relatively to the overall plan. With them läst move the indicated screen window. If you click with the left mouse key the square badges of the strip and move with low-spirited key, the plan cutting follows the movements. Click with the left mouse key on one of the arrows at the end of the picture run strip, the picture is shifted around about 1/10 of the shown screen window. Clicking the real picture run strip shifts the visible cutting around about 1/4.

Screen window shift

The plan view is shifted by clicking with the left mouse key around a screen area to the right, on the left, on top or below. The edge of the plan segment about one tenth of the screen width - remains visible also in the connection picture.

Detailed window

They can provide an additional detailed window to the called plan, while you with at the same time low-spirited left mouse and Shifttaste the desired screen area diagonally draw up: In the plan appears a frame. While letting go the mouse key the detailed window with him opens framed plan area.

Alternatively you click first with the left mouse key the symbol of the tool box or the menu entry view | Window | new detail in. Then you lay the detailed window firmly by click in the graphics window on the left lower and right upper corner of the desired screen window. The additional detailed window appears. As while zooming you also have to go here twice with the left mouse key click, the window is able on clicking the symbol in the tool box or the menu entry no more are opened by drawing with the mouse.